How do you know? Energy Compliance-Washington State Energy Code
Wenatchee Home Inspections
New construction requires builders to hit some energy efficiency marks, or as the code state credits. The amount of credits you will need to achieve will be based on the size of the home.
Here is the the credits required based on size-
1. Small Dwelling Unit: 1.5 credits
Dwelling units less than 1500 square feet in conditioned floor area with less than 300 square
feet of fenestration area. Additions to existing building greater than 500 square feet of heated
floor area but less than 1500 square feet.
2. Medium Dwelling Unit: 3.5 credits
All dwelling units that are not included in #1 or #3.
Exception: Dwelling units serving R-2 occupancies shall require 2.5 credits.
3. Large Dwelling Unit: 4.5 credits
Dwelling units exceeding 5000 square feet of conditioned floor area.
Exception: Dwelling units serving R-2 occupancies shall require 2.5 credits.
4. Additions less than 500 square feet: 0.5 credits
The energy code gives you several ways to achieve these credits typically made up of several approaches such as “HIGH EFFICIENCY HVAC EQUIPMENT 3b: Air-source heat pump with minimum HSPF of 9.0” this will give you 1.0 credits or “EFFICIENT WATER HEATING 5c: Electric heat pump water heater with a minimum EF of 2.0 and meeting the standards of NEEA’s Northern Climate Specifications for Heat Pump Water Heaters” this earns you 1.5 credits.
(Here is a list of the credits you can achieve- http://www.energy.wsu.edu/Documents/Table_406.2_2015_Energy_Credits.pdf )
So if you are inspecting new construction and looking to evaluate some of these components you need some information to make observations. This information comes in the form of an “Energy Compliance Certificate”. This is to be filled out by the builder or design professional. This is a required on all new homes and goes back a few code cycles.
2015 IRC–
R401.3 Certificate
A permanent certificate shall be completed and posted on or within three feet of the electrical distribution panel by the builder or registered design professional. The certificate shall be completed by the builder or registered design professional. The certificate must list the energy features of the structure.
Checklist and Certification-
http://www.energy.wsu.edu/Documents/2015_Prescriptive_Checklist.pdf
http://www.energy.wsu.edu/Documents/WSEC-2015-Avery-6573_2_Per_Sheet.pdf
One problem I am running into on new construction is that these certificates are not being completed (Example below). Thus I am not able to always know what some of the energy requirements are required. This may be particularly good to know when looking at insulation, does the house require R-38 or R-49 insulation in the attic, or R-30 vs R-38 insulation in crawlspaces?
(Names erased to protect the not so innocent)
So when buying a new home or if performing a home inspection on new construction I would recommend verifying that the energy compliance certificate is present and complete.
You can only teach someone, as much as they are willing to learn."
Chris G. Varona
If you find any errors or have additional information that would expand on any code, building standards or manufacturer requirements please let me know.
NCW Home Inspections, LLC is a Licensed Washington State Home Inspection service located in Wenatchee Washington serving Chelan County, Douglas County, Kittitas County, Okanogan County and Grant County Washington and the cities of Wenatchee, Leavenworth, Cashmere, Oroville, Cle Elum, East Wenatchee, Quincy and many more…
Your Wenatchee and Chelan Professional Real Estate, Home and Structural Pest Inspection Service
Instructor- Fundamentals of Home Inspection- Bellingham Technical College
WA Home Inspector Advisory Licensing Board
www.ncwhomeinspections.com 509-670-9572
You can follow me on Facebook, Twitter, Google+ and on my website Blog.
How do you know? Energy Compliance-Washington State Energy Code
Wenatchee Home Inspections
New construction requires builders to hit some energy efficiency marks, or as the code state credits. The amount of credits you will need to achieve will be based on the size of the home.
Here is the the credits required based on size-
1. Small Dwelling Unit: 1.5 credits
Dwelling units less than 1500 square feet in conditioned floor area with less than 300 square
feet of fenestration area. Additions to existing building greater than 500 square feet of heated
floor area but less than 1500 square feet.
2. Medium Dwelling Unit: 3.5 credits
All dwelling units that are not included in #1 or #3.
Exception: Dwelling units serving R-2 occupancies shall require 2.5 credits.
3. Large Dwelling Unit: 4.5 credits
Dwelling units exceeding 5000 square feet of conditioned floor area.
Exception: Dwelling units serving R-2 occupancies shall require 2.5 credits.
4. Additions less than 500 square feet: 0.5 credits
The energy code gives you several ways to achieve these credits typically made up of several approaches such as “HIGH EFFICIENCY HVAC EQUIPMENT 3b: Air-source heat pump with minimum HSPF of 9.0” this will give you 1.0 credits or “EFFICIENT WATER HEATING 5c: Electric heat pump water heater with a minimum EF of 2.0 and meeting the standards of NEEA’s Northern Climate Specifications for Heat Pump Water Heaters” this earns you 1.5 credits.
(Here is a list of the credits you can achieve- http://www.energy.wsu.edu/Documents/Table_406.2_2015_Energy_Credits.pdf )
So if you are inspecting new construction and looking to evaluate some of these components you need some information to make observations. This information comes in the form of an “Energy Compliance Certificate”. This is to be filled out by the builder or design professional. This is a required on all new homes and goes back a few code cycles.
2015 IRC–
R401.3 Certificate
A permanent certificate shall be completed and posted on or within three feet of the electrical distribution panel by the builder or registered design professional. The certificate shall be completed by the builder or registered design professional. The certificate must list the energy features of the structure.
Checklist and Certification-
http://www.energy.wsu.edu/Documents/2015_Prescriptive_Checklist.pdf
http://www.energy.wsu.edu/Documents/WSEC-2015-Avery-6573_2_Per_Sheet.pdf
One problem I am running into on new construction is that these certificates are not being completed (Example below). Thus I am not able to always know what some of the energy requirements are required. This may be particularly good to know when looking at insulation, does the house require R-38 or R-49 insulation in the attic, or R-30 vs R-38 insulation in crawlspaces?
(Names erased to protect the not so innocent)
So when buying a new home or if performing a home inspection on new construction I would recommend verifying that the energy compliance certificate is present and complete.
You can only teach someone, as much as they are willing to learn."
Chris G. Varona
If you find any errors or have additional information that would expand on any code, building standards or manufacturer requirements please let me know.
NCW Home Inspections, LLC is a Licensed Washington State Home Inspection service located in Wenatchee Washington serving Chelan County, Douglas County, Kittitas County, Okanogan County and Grant County Washington and the cities of Wenatchee, Leavenworth, Cashmere, Oroville, Cle Elum, East Wenatchee, Quincy and many more…
Your Wenatchee and Chelan Professional Real Estate, Home and Structural Pest Inspection Service
Instructor- Fundamentals of Home Inspection- Bellingham Technical College
WA Home Inspector Advisory Licensing Board
www.ncwhomeinspections.com 509-670-9572
You can follow me on Facebook, Twitter, Google+ and on my website Blog.