• Skip to main content
  • Skip to primary sidebar

Administrator

The Confluence of Quality and Integrity

Should you stay with R22 or its replacement refrigerant R-421A?

September 3, 2017 by danmcconnon

Should you stay with R22 or its replacement refrigerant R-421A?
Wenatchee Home Inspections


HVAC systems are not cheap and making a decision to repair an older system versus replacement has many varying factors.

A little background R-22 ( Freon) was the popular refrigerant up to around 2010. Pre-2010 you will find R22 on some systems but many were starting to move over to the replacement refrigerant R-410A.

    

In 1987 there was an agreement called the Montreal Protocol. This agreement established requirements that started the worldwide phase-out of ozone-depleting CFCs (chlorofluorocarbons) which the refrigerant R-22 (HCFC-22) is part of. In 2020 (just 3 years away) there will be no production or importing of HCFC-142b and HCFC-22, so all that will be available is what is reclaimed or recycled.

There is other reasons to move on and that is efficiency.  The newer R-410A refrigerant is a more efficient refrigerant.





Most R-22 systems have a top end efficiency of 13/14 SEER  (Seasonal Energy Efficiency Ratio). I have heard you can reach 18 SEER but have never seen one  Many of older R-22 systems may have an efficiency of 9 SEER or less.  




R-410A systems will start at a SEER 13/14 (Which is a minimum requirement as of 2015) with ultra high efficiency systems will be 20 SEER or more.





Another option for repairs on older R-22 systems is R-421A. This is a replacement refrigerant for R22 without unit modifications of the system and does not contain hydrocarbons, such as Butane, Isopentane or Isobutane.  ( http://rmsgas.com/pdfs/R421A%20rev%205-08.pdf )







System replaced with R-421A



You will still not see any efficiency increases with this replacement.



http://www.fire.nist.gov/bfrlpubs/build02/PDF/b02186.pdf

To gain the efficiency, performance and environmental benefits of R410a refrigerant, you will need to install a new system that is designed to use the refrigerant due to its higher pressures. If your air conditioner or heat pump is nearing the end of its life, the efficiency of the R410a refrigerant system might be a good reason to replace your system sooner rather than later so that you can avoid the rising costs of repairing a refrigerant leak with R22 refrigerant.

 


"You cannot teach a man anything; you can only help him find it within himself."

Galileo

 


If you find any errors or have additional information that would expand on any code, building standards or manufacturer requirements please let me know.



NCW Home Inspections, LLC  is a Licensed Washington State Home Inspection service located in Wenatchee Washington serving Chelan County, Douglas County, Kittitas County, Okanogan County and Grant County Washington and the cities of Wenatchee, Leavenworth, Cashmere, Oroville, Cle Elum, East Wenatchee, Quincy and many more…  

Your Wenatchee and Chelan Professional Real Estate, Home and Structural Pest Inspection Service

Instructor- Fundamentals of Home Inspection-  Bellingham Technical College

WA Home Inspector Advisory Licensing Board

www.ncwhomeinspections.com                                                   509-670-9572

You can follow me on Facebook, Twitter, Google+ and on my website Blog.

                      




 


 




Should you stay with R22 or its replacement refrigerant R-421A?
Wenatchee Home Inspections


HVAC systems are not cheap and making a decision to repair an older system versus replacement has many varying factors.

A little background R-22 ( Freon) was the popular refrigerant up to around 2010. Pre-2010 you will find R22 on some systems but many were starting to move over to the replacement refrigerant R-410A.

    

In 1987 there was an agreement called the Montreal Protocol. This agreement established requirements that started the worldwide phase-out of ozone-depleting CFCs (chlorofluorocarbons) which the refrigerant R-22 (HCFC-22) is part of. In 2020 (just 3 years away) there will be no production or importing of HCFC-142b and HCFC-22, so all that will be available is what is reclaimed or recycled.

There is other reasons to move on and that is efficiency.  The newer R-410A refrigerant is a more efficient refrigerant.





Most R-22 systems have a top end efficiency of 13/14 SEER  (Seasonal Energy Efficiency Ratio). I have heard you can reach 18 SEER but have never seen one  Many of older R-22 systems may have an efficiency of 9 SEER or less.  




R-410A systems will start at a SEER 13/14 (Which is a minimum requirement as of 2015) with ultra high efficiency systems will be 20 SEER or more.





Another option for repairs on older R-22 systems is R-421A. This is a replacement refrigerant for R22 without unit modifications of the system and does not contain hydrocarbons, such as Butane, Isopentane or Isobutane.  ( http://rmsgas.com/pdfs/R421A%20rev%205-08.pdf )







System replaced with R-421A



You will still not see any efficiency increases with this replacement.



http://www.fire.nist.gov/bfrlpubs/build02/PDF/b02186.pdf

To gain the efficiency, performance and environmental benefits of R410a refrigerant, you will need to install a new system that is designed to use the refrigerant due to its higher pressures. If your air conditioner or heat pump is nearing the end of its life, the efficiency of the R410a refrigerant system might be a good reason to replace your system sooner rather than later so that you can avoid the rising costs of repairing a refrigerant leak with R22 refrigerant.

 


"You cannot teach a man anything; you can only help him find it within himself."

Galileo

 


If you find any errors or have additional information that would expand on any code, building standards or manufacturer requirements please let me know.



NCW Home Inspections, LLC  is a Licensed Washington State Home Inspection service located in Wenatchee Washington serving Chelan County, Douglas County, Kittitas County, Okanogan County and Grant County Washington and the cities of Wenatchee, Leavenworth, Cashmere, Oroville, Cle Elum, East Wenatchee, Quincy and many more…  

Your Wenatchee and Chelan Professional Real Estate, Home and Structural Pest Inspection Service

Instructor- Fundamentals of Home Inspection-  Bellingham Technical College

WA Home Inspector Advisory Licensing Board

www.ncwhomeinspections.com                                                   509-670-9572

You can follow me on Facebook, Twitter, Google+ and on my website Blog.

                      




 


 


Primary Sidebar

  • Menu
  • Gallery
  • Blog

Informational Pages

  • Blog
  • Foundation Certifications
  • Prices
  • Qualifications
  • Services Performed
  • Testimonials
  • Washington State Home Inspector Standards of Practice
  • What’s Inspected and Services
  • Areas Served
  • Credit card
  • City/County/State Building Codes
  • Frequently Asked Questions
  • General Home Information
  • Homeowner Maintenace Guides
  • Infrared Thermography
  • Recall Resources
  • Reference Documents
  • Inspection Agreement and Washington State Standards of Practice
  • Home and Building Inspections Wenatchee, Chelan and Surrounding Areas
    • About Me and Training Information
  • google verify

Copyright © 2025 Administrator. All rights reserved.